[. . . ] Biz MOWCART Instruction manual Please read these instructions carefully and make sure you understand them before using this machine. 3 18 22 29 31 39 62 65 We reserve the right to make changes without prior notice. Safety rules Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAPABLE OF AMPUTATING HANDS AND FEET AND THROWING OBJECTS. fAILURE TO OBSERVE THE FOLLOWING SAFETY INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH. [. . . ] WARNING: Backing up with the deck clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the deck clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. USING THE REVERSE OPERATION SYSTEM Only use if you are certain no children or other bystanders will enter the mowing area. € With engine running, turn ignition key counterclockwise to ROS "ON" position. • Slowly move motion control lever to reverse (R) position to start movement. € When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position. 35 5 Cutting tips • • • • • Clear the lawn from stones and other objects which can be thrown away by the blades. Begin with a high cutting height and reduce until the required cutting result is obtained. If the grass is not too long and thick the drive speed can be increased by selecting a higher gear without affecting the cutting result. Cutting becomes more even and the cut grass is more evenly distributed over the surface. Total time taken is not greater, since higher drive speed can be selected without affecting the cutting results. The cutting results will be worse since the wheels will sink into the soft lawn. € • • Do not drive in terrain at an angle of more than max. € • Drive in right turns so that the cut grass is thrown away from flower beds and paths, etc. For larger lawns the drive direction should be changed after 2-3 turns so that the cut grass is thrown towards the area that has already been cut as shown in the illustration. Use the left side of the machine to cut close to trees, bushes and paths, etc. 37 5 Switching off the engine Move the deck clutch lever to disengaged position. Lift up the mower deck and turn the ignition key to “STOP” position. Do not leave the ignition key in the machine when not in use to prevent children and other unauthorized persons starting the engine. Before servicing the engine or cutting unit the following shall be carried out: • Press down the clutch/brake pedal and engage the parking brake lever. 39 6 Maintenance NOTE: Periodic maintenance should be performed on a regular basis in order to keep your riding mower in good running condition. WARNING: Disconnect spark plug wire to prevent accidental starting before attempting any repair, inspection, or maintenance. [. . . ] € While sitting in the operator’s position on the tractor, restart the " position. Engine and place the throttle lever in the Fast " IMPORTANT: Recheck the area making certain the area is clear. € Move the tractor’s attachment clutch control to the “Engaged” position. Remain in the operator’s position with the cutting deck engaged until the deck is cleaned. [. . . ]